Great Plains YP625PD Predelivery Manual - Manual (Page 59)

Great Plains Manufacturing, Inc. Contents Index Planter Assembly 55
07/05/2011 Contents Index 401-754Q
Install SMV
SMV (Slow Moving Vehicle reflector) installation is
different for pull-type (“PD”: below) and 3-point
(“TD”: page 56).
PD: Install Pull-Type SMV
Refer to Figure 113 and Figure 114
PD: Install SMV on Mount
If the SMV
is already installed on its mount, continue
at “PD: Install SMV Mount”.
251. Select one each:
818-055C DECAL SLOW MOVING-GALV. BACKED
406-025D SMV MOUNT BRACKET
and two sets:
802-196C HFSS 1/4-20X5/8 GR5
803-230C NUT HEX FLANGE 1/4-20 PLT
252. Insert the bolts through the reflective face of the
SMV . Attach the SMV, narrow end up, wide end
down, to the long break of the bracket , on the
side away from the lower double break. Secure with
flange nuts
.
Null4:
PD: Install SMV Mount
253. Select one each:
806-191C U-BOLT 3/8-16X1 17/32X2 1/2
and two:
803-068C NUT HEX FLANGE 3/8-16 PLT
254. With the SMV reflective surface on top and facing to
the rear, attach the bracket to the air pipe
support tube using the U-bolt and two
flange nuts . Place the assembly at or near
planter center-line.
Null4:
Null4:
Figure 113
SMV Components
31803
187
294
344
205
302
270
375
375
205
270
302
270
375
205
302
Null4:
Figure 114
Install SMV
Q0090
187
270
294
205
194
344
294
205
194 344
294