ClearOne Converge 590 - Manual (Page 81)

Appendix 87
CONVERGE SERIAL COMMANDS (CONTINUED)
Command Function
GREPORT Selects/reports gate status report frequency
HOOK Sends a hook flash
HOOKD Selects/reports hook flash duration
LABEL Selects/reports label of specified channel or unit
LOCALNUM Sets/reports current value of local number
LOGMASK Sets or reports the unit event log mask
LVL Reports in, out or processor level
LVLREPORT Selects/reports level status
LVLREPORTEN Enables/disables level reporting
MANUFACTURER Selects/reports manufacturer identification label
MICCAMPRESET Associate a microphone with a camera preset
MLINE Selects/reports the setting of coarse gain
MTRX Selects/reports matrix routing of an in to out
MUTE Sets/reports mute status
NCD Selects/reports the setting of noise cancellation for a mic input
NCSEL Enables/disables or reports current status of noise cancellation
NLP Selects/reports the setting of non-linear processing for each mic
channel
OFFA Selects/reports the off attenuation mode of a mic channel
PBDIAL Dials speed dial number by name
PHONEBOOKADD Saves entry in the phonebook
PHONEBOOKCNT Queries number of entries in phonebook
PHONEBOOKDEL Deletes an entry in the phonebook
PHONEBOOKREAD Queries an entry in the phonebook
PP Reports the setting of phantom power
REDIAL Redials last number called
RESET Resets the unit
RFFREQ Sets/reports frequency for RF link to remote
RING Indicates a ringing line
RINGERLVL Selects/reports audible ring level
RINGERSEL Sends/reports audible ring melody
RINGERTEST Plays current audible ringer melody
SILENCEPRST Associates camera preset with silence for voice tracking
SPEEDDIAL Dials speed dial number by speed dial number
SPLIFT Selects/reports the setting of the speech lift enable processing for
each mic channel
SPLEVEL Selects/reports the setting of the speech lift level for each mic
channel
STEREOMIX Enables/disables or reports stereo mix status
SYSCHECKS Initiates system checks
SYSRESULT Reports the results of the system check
TE Selects/reports hook status
TELCOLVLCTRL Selects/reports setting of Telco TX level control
TIMELOCALE Sets or reports the time locale settings
UCLOCK Sets or reports the current time.
UID Reports unit ID (read only)
VER Reports unit version (read only)
VOLUME Changes/reports the gain for the output channel