ClearOne Converge 590 - Manual (Page 37)

RAV-Ware Software Configuration 37
BREAKOUT BOX GATING TAB
Click on the Gating tab from the Microphone Settings screen to access microphone gating
features. You can control the gating mode, set the gate ratio, hold time, and attenuation,
set the decay rate, and control chairman override from this tab (see figure 3.9).
To set Gate Mode
Set Gate Mode allows you to set the gate mode. Choices are limited to manual on,
override on, and auto. Manual on activates a mic; the microphone contributes to gating
parameters. Override on activates a mic; the microphone does not contribute to gating
parameters. Auto automatically gates the mic on or off, based on input levels and other
parameters programmed into the Converge 560/590.
1. Click the Gate M Mode radio button corresponding with the desired setting.
To adjust Gate Ratio
Gate ratio specifies how much louder the mic audio level must be above the ambient
noise level before the mic gates on (see figure 3.10).
1. Using the slider, adjust the gate ratio to the desired level.
FIGURE 3.9 Microphone settings: gating tab (Converge 560 shown)