ClearOne Converge 590 - Manual (Page 73)

Appendix 79
SPEAKERS
The following paragraphs outline speaker troubleshooting.
Neither speaker plays
Check that the wires are properly connected. Check the audio mixer in RAV-Ware to
ensure the audio is routed to the loudspeakers. Check volume setting and mute status.
Bass and treble are weak
Check the equalization for the loudspeakers in RAV-Ware.
Only one speaker plays
Check the equalization for the loudspeakers in RAV-Ware. Check the wires connected to
the speaker that does not play. Be sure the wires are in good condition and are firmly
connected.
One speaker still does not play
Disconnect the wires from both the speaker and the mixer. Disconnect the other wire from
its speaker and connect that end of the wire to the speaker that doesn't play. If the speaker
still doesn't play, the problem is in the speaker. If the speaker now plays, continue check-
ing for the source of the problem. Disconnect the same wire from the mixer. Connect it to
the other output. If the speaker plays, the problem is the original wire that was connected
to that speaker.
GENERAL
The following paragraphs outline general troubleshooting.
Physical damage to Converge
All repairs must be done by a ClearOne technician. Call ClearOne technical support for
more information.