ClearOne Converge 590 - Manual (Page 20)

20 Technical Services: 800.283.5936
CONNECTING FOR SERIAL CONTROL
You can connect a computer or a control device, such as an AMX or Crestron, to the
Converge mixer through the serial control port. See page 83 for a list of the serial
commands.
To connect to a computer through the serial port
1. Connect computer to Control port on the back of the mixer using a 9-pin straight-
through serial cable.
CONNECTING FOR USB CONTROL
You can also connect a computer to the Converge through the USB port.
To connect to a computer through the USB port
1. Connect computer to the USB port on the front of the mixer using a USB cable.
MIC POD IN
CAMERA
CONTROL LAN RS-232
TELEPHONE
SET
FIGURE 2.18 Connecting a computer serially
FIGURE 2.19 Connecting a computer through the USB