ClearOne Converge 590 - Manual (Page 31)

RAV-Ware Software Configuration 31
To change telephone preferences
1. In the Preferences tab, set the system to
Auto-A Answer after 2 R Rings or 4 R Rings or
select Disabled if you want to manually
answer calls.
2. Select Auto-D Disconnect if you would like
Converge to disconnect when it detects
loop-drop or call progress tones.
3. Select from three available ringer
melodies. Click Ringer TTest to hear
selected melody.
> Note: This option is only available when you are connected to a Converge unit.
4. Select Audible C Connect if you would like one tone to sound when the Converge is
taken off hook and two tones to sound when the Converge is on hook.
5. Adjust ringer volume using the Ringer Level slider.
6. Enter the Local N Number for the Converge system. The local number displays on the
third line of the Controller LCD.
To select telephone configuration
1. In the Configuration tab, select the Country
where the phone is being used.
2. Select the flash duration from the Flash
Setting list. This setting is dependent on the
requirements of your PBX or telephone
provider.
Warning: The country code must be set
correctly in RAV-Ware and the RF Controller
to ensure that the unit operates properly and
that it complies with the country’s telco
requirements. Changing this code to a country other than the intended country of
operation might cause the Converge to be non-compliant.
To adjust telephone level
1. Select Receive A ALC. Clearone recommends
keeping Receive ALC (automatic level control)
selected. This feature adjusts the far-end audio
to keep it at a constant level.
2. Use the sliders to adjust the level of the telco
transmit and telco receive.
> Note: If you select ALC, the Telco Receive
slider is disabled.
3. Click OK to save settings and close the
window.