ClearOne Converge 590 - Manual (Page 29)

RAV-Ware Software Configuration 29
To change the User Name and Password
1. In the Networking tab, click User/Password.
2. Specify the User N Name.
3. Type the Password.
4. Retype the password to confirm.
5. Click OK to save changes and close the window.
> Note: This option is only available when you are con-
nected to a Converge unit. User Name and Password
are not case sensitive and can be between 1 and 12
characters.
To configure the Camera port
1. In the Serial tab, set the Baud R Rate to
match the baud rate indicated in the
camera specifications.
2. Select Flow C Control to enable hardware flow
control.
3. Click OK to save settings and close the
window.
To configure the Control port
1. Set the Control Port Baud R Rate to match the
baud rate of the PC COM port or the control
device.
2. Select Flow C Control to enable hardware flow
control. (Flow Control is selected as default
in wireless units.)
3. Click OK to save settings and close the
window.
> Note: Flow control is the regulation of information between two devices that are
connected to one another.
Attention: If you are connected to the Converge unit through the serial port, you will
need to reboot the unit before the baud rate and flow control changes take place. If
you are connected to the Converge unit through the USB port or Ethernet, changes
are made instantly.