ClearOne Converge 590 - Manual (Page 63)

Using the Converge 63
To perform RF Radio Test on RF Controller
1. Press to access the menu options.
2. Scroll to Configuration and press .
3. Scroll to RF Radio Test and press .
4. Press to exit and return to the
Configuration menu.
> Note: The RF Controller will send out a radio
signal and display the signal strength
between the Controller and the mixer. Use
this feature to ensure the mixer and
Controller are set to the same frequency and
to verify of the signal strength. Use the chart
to determine the reliability of the signal.
Attention: If you are having trouble with the
communication between the Controller and
the mixer, refer to the Troubleshooting guide
for tips on improving signal strength.
To change LCD contrast
1. Press to access the menu options.
2. Scroll to Configuration and press .
3. Scroll to Contrast and press .
4. Choose a contrast setting (0-3).
5. Press to select the contrast and
return to the Configuration menu.
To view the IP address
1. Press to access the menu options.
2. Scroll to Configuration and press .
3. Scroll to IP Address and press .
> Note: The IP address for the Converge
unit will display on the LCD.
4. Select Exit to return to the Configuration window.
RF Radio Test
Exit
-------
RF radio test
Signal Level Reliability
Fair
Good
Better
Best
0–4 bars
4–8 bars
9–12 bars
13–16 bars
Signal strength reliability
Contrast 0
Contrast 2
Contrast 1
*
Contrast
IP Address
Exit
191.151.147.102
IP address