ClearOne Converge 590 - Manual (Page 30)

30 Technical Services: 800.283.5936
To change RF frequency channel (RF Controller only)
1. In the Frequency tab, select a frequency.
2. Click OK to save settings and close the
window.
> Note: The channel frequency allows the mixer
to communicate with the controller. The
frequency used by RAV-Ware must match the
frequency used by the controller. See page 62
to set the controller frequency.
Attention: If you are using the European or
South African version of Converge, Frequency
1 and Frequency 8 are the same frequency.
REGIONAL SETTINGS
In the Regional Settings window, you can configure the date and time to ensure an accu-
rate time stamp on log files.
To open Regional Settings
1. Click the Regional S Settings icon in the Configuration screen or
select Regional S Settings from the Tools menu.
To set date and time
1. Select Use LLocal TTime if you want to use
the time on your local computer. Or clear
the Use LLocal TTime checkbox and enter
the IP address for the time server.
2. Select Use D Daylight S Savings if your region
observes daylight savings time.
3. Select your Time ZZone and click OK.
4. Click Yes to confirm changes.
TELEPHONE SETTINGS
In the Telephone Settings window you can set telephone preferences such as auto-answer,
auto-disconnect, ringer melody and program the local number. You can also adjust the
telco level control, country setting and the flash settings.
To open Telephone Settings
1. Click the Telephone S Settings icon in the Configuration screen.