ClearOne Converge 590 - Manual (Page 32)

32 Technical Services: 800.283.5936
CUSTOMIZING CONVERGE COMPONENTS
Your Converge system is pre-configured for optimal audio quality right out of the box.
However, you can customize the audio and adjust the volume to match user preferences.
You can also change the mix of audio being sent to the far-end conference site and
recording devices.
MICROPHONE BREAKOUT BOXES
The Converge 590 has three breakout boxes representing three sets of three microphones
each; the Converge 560 has two breakout boxes representing two sets of three
microphones each. Control for all of the microphones is done through the breakout box
tabs: Level, Processing, and Gating. You can enable/disable automatic level control (ALC)
settings, enable/disable mute, enable/disable phantom power, enable/disable acoustic
echo cancellation, enable/disable noise cancellation,
enable/disable speech lift, adjust speech lift level,
control gating mode, set gate ratio, hold time, and
attenuation, set the decay rate if the gate is lost, and
set chairman override.
To access Microphone Settings
1. Click the Breakout icon on the Configuration screen. The breakout box settings screen
appears with the Level tab selected.
FIGURE 3.6 Microphone settings: level tab (Converge 560 shown)