ClearOne MUR2EM Quick Start - Manual

NS-1005-7144 1
All specifications subject to change without notification. All rights reserved. Copyright © 2005 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
Quick Start Guide
The MUR2EM connects to the Musica MU5066ADC. It allows the home owner to control the Musica system through a Flash-
enabled web browser. For more detailed instructions, download the Musica MUR2EM Installation guide from
www.netstreams.com .
Hardware Requirements
To complete an installation for a single MUR2EM, you will need:
 an MUR2EM. Part Number: NS-MUR2EM,
 a NetStreams Musica MU5066 Audio Distribution Center
®
(ADC).
Part Number: NS-MU5066ADC,
 a hub/switch,
 a computer with serial port (or USB to serial adapter),
 an Ethernet cable,
 an RS-232 cable,
 a power cable for the MUR2EM,
 a power cable for the Musica MU5066ADC, and
 a power cable for the hub/switch.
Software Requirements
 Flash Macromedia
®
running on the web browser device.
 Windows XP, SP2.
 a Flash-compatible web browser.
Configuring the IP Address
To configure the IP address for the MUR2EM, you must first connect the hardware, then use HyperTerminal to complete the
configuration.
Connecting the MUR2EM
To connect the MUR2EM for IP configuration, complete the following steps:
1. Connect the MUR2EM to the computer using the null modem cable provided.
NOTE: If your computer does not have a serial port, you need to use an adapter that converts USB to serial. Note the COM
port number.
2. Connect the Ethernet port of the MUR2EM to the home network switch.
3. Connect the Ethernet port of the computer to the home network switch.
4. Ensure all power cables are plugged in.
5. Start the computer.
Configuring the IP Address
This section shows you how to configure the IP address for your MUR2EM that matches the IP address scheme for the home
network.