ClearOne Converge 590 - Manual (Page 18)

18 Technical Services: 800.283.5936
To connect a sound card
1. Using an RCA cable, connect the Line IIn on the Converge mixer to the line out on a
sound card.
2. Using an RCA cable, connect the Line O Out on the Converge mixer to the line in on a
sound card.
To connect to an amplifier
1. Using an RCA cable, connect the Line O Out or Record O Out on the Converge mixer to
the line in on an amplifier.
> Note: Use RAV-Ware to adjust the equalization and volume of these devices. Refer to
pages 39–46 for more information. When using RAV-Ware, be sure to drag the amplifi-
er to the correct device (either line out or record). This will properly assign the AEC
reference and change the volume command on the controller to control the external
amplifier volume.
IN
OUT
LINE
FIGURE 2.14 Connecting a sound card
IN
OUT
LINE
R
FIGURE 2.15 Connecting an amplifier