ClearOne Converge 590 - Manual (Page 62)

62 Technical Services: 800.283.5936
To select a frequency on RF Controller
1. Press to access the menu options.
2. Scroll to Configuration and press .
3. Scroll to Frequency and press .
4. Choose a frequency from 1-8.
5. Press to save the frequency and
return to the Configuration menu.
> Note: The channel frequency allows the mixer to communicate with the controller. The
frequency in RAV-Ware must match the Converge controller frequency. See page 30.
> Note: If you are using the European or South African version of Converge, frequency 1
and frequency 8 are the same frequency.
To enter Flash Duration
1. Press to access the menu options.
2. Scroll to Configuration and press .
3. Scroll to Flash Duration and press .
4. Type the duration number from 50-1000
ms in 10 ms steps.
5. Press to save the duration and return to the Configuration menu.
To enable wired controller
1. Press to access the menu options.
2. Scroll to Configuration and press .
3. Scroll to Wired Controller and press .
4. Enable and Disable are displayed. Select Enable and press .
5. The mixer resets and the wired controller is enabled.
Frequency 1
Frequency 2
*
Frequency 3
Select a frequency
1000
Save
Enter flash settings