ClearOne Converge 590 - Manual (Page 11)

Introduction 11
INSTALLATION OVERVIEW
Carefully consider the following items in order to ensure yourself of a smooth installation
process.
READ THE USER MANUAL
Please read through this manual to familiarize yourself with the Converge system. Refer to
the Help file in RAV-Ware for information on the software. Read through all requirements
and safety information to be sure you set up and configure your Converge correctly.
MAKE SURE YOUR NETWORK IS READY
Review all system requirements. Then check with your network administrator to be sure
your network meets all the Converge requirements.
CONNECT CABLES
Connect cables. If you are planning on using the Converge for web or videoconferencing,
you’ll need to connect peripheral equipment. See Chapter 2, Connecting the Converge.
INSTALL SOFTWARE
Install RAV-Ware and then use to adjust sound levels and to configure settings for
additional equipment such as a video codec or a recording device. See Chapter 3, RAV-
Ware Software Configuration.
BEGIN USING
Use the controller to answer and make calls. See Chapter 4, Using the Converge.
SYSTEM REQUIREMENTS FOR RAV-WARE
> Note: Using a USB-to-serial adapter is not recommended.
Operating System and RAM
Windows 2000 256 MB RAM
Windows XP 256 MB RAM
Processor 300 MHz Pentium III or better
Monitor 1024 x 768 SVGA (16 bit) high color
Video Card SVGA 1024 x 768 minimum
Free Hard Disk Space 20 MB minimum
RS-232 COM port Up to 115,200 baud rate
USB port USB 1.1–2.0
Flash Support Macromedia Flash Player 7.0
Component Requirement