ClearOne Converge 590 - Manual (Page 65)

Using the Converge 71
ACCESSING THE WEB INTERFACE
The Converge has a built-in web server that provides a remote access interface to your
Converge system. However, not all programming and metering functions are available. The
web interface allows you to connect to a Converge unit, run system checks, view the event
log and manage calls.
To use the web interface from outside your network, your firewall must be properly configured
to allow access. If you are accessing Converge from within the network, you may be able to
use the network name. The web interface uses Port 80.
TO CONNECT TO CONVERGE THROUGH THE WEB INTERFACE
1. Open a web browser and enter the IP aaddress or Network N Name of the Converge in
the address bar.
2. Enter your User N Name and Password.
The default user name is ClearOne and
the default password is RAV.
The Converge web interface opens.
Navigation buttons are shown in the left
channel.
WEB INTERFACE
FIGURE 5.1 Converge 590 RAV-Ware management system