Cabletron Systems 6A000/ZX-250 - Manual (Page 73)

SmartCell 6A000/ZX-250 Reference Manual 2-49
Console Commands
IISPRoute
Use IISPRoute (interim inter-switch signaling protocol) to manipulate the IISP routes configured on the switch (see
“UNIRoute” for further routing commands).
Operators
add, delete, show, flush
Parameters
SERVER SVC
X X
Input Parameter Description Value/Field Size Default
[ATMAddress] ATM address assigned to the port, client, or server. 13-20 byte hex-based/
Up to 59 characters
NONE
[PortNumber] Port number on the switch. A1...A4, B1...B3,
C1...C4, D1...D4 A1
[Metric] Metric value. Used when the next hop is
accessible through various parallel links. If there
are two IISP routes to a destination, every time a
call setup arrives, it is routed using one of the
parallel IISP routes, alternatively. You can specify
the number of times each route is used in a row by
the metric variable. 1-5 1
[EntryIndex] Index into the IISP route table for the IISP ATM
address entry. 2 characters 0
Output Parameter Description
[Length] Address length in number of bits. IISP allows you to enter any number of bits. Only
multiples of a byte (an even number of bits) can be entered and the calculated address
length is displayed.