Cabletron Systems 6A000/ZX-250 - Manual (Page 157)

SmartCell 6A000/ZX-250 Reference Manual 2-133
Console Commands
[Port QSAAL State] Signaling AAL (ATM adaptation layer).
Indicates if the SSCOP (service specific
connection oriented protocol) link is up or
down. UP, DOWN UP
[Port Operational State] State of the link, based on port status (set by
internal protocols). UP, DOWN DOWN
[Transmission Type] Type of transmission. STS-3c, STS-12c,
STM-1, STM-4
[Media Type] Media type can be either copper or fiber. Fiber
can be either single mode or multimode. MMF, SMF,
UTP-5
[Bandwidth] Bandwidth in Mbps for the port. 155 Mbps, 622 Mbps
[Address Type] ATM address format. PRIVATE,
NSAP-E164,
NATIVE-E164,
OTHER
PRIVATE
[Active VPI Bits] Active VPI bits are programmed in hardware. A
minimum/maximum algorithm is used to find
the hardware programmed VPI/VCI set that
corresponds most closely to VPI/VCI values
requested for a specific port. 0-12 0
[Active VCI Bits] Active VCI bits are programmed in hardware. A
minimum/maximum algorithm is used to find
the hardware programmed VPI/VCI set that
corresponds most closely to the VPI/VCI values
requested for a specific port. 0-12 12
[Configured VPI Bits] Number of VPI bits configured by the user. 0-7 0
[Configured VCI Bits] Number of VCI bits configured by the user. 5-12 12
[Current VPI Bits] Current VPI bits are derived from the VPI/VCI
set closest to the configured, as well as active,
VPI/VCI sets. Used by the software when
generating VPIs and VCIs. Often equal to active
VPI bits. 0-12 0
Output Parameter Description Value/Field Size Default