Cabletron Systems 6A000/ZX-250 - Manual (Page 135)

SmartCell 6A000/ZX-250 Reference Manual 2-111
Console Commands
LogTrace
Use LogTrace to control filtering and configuration parameters for logging and tracing messages.
Operators
modify, show
Parameters
SERVER SVC
X X
Parameter Description Value/Field Size Default
[LocalPortNum] The port through which remote log trace clients can
connect to the switch and receive messages. 5 characters 6005
[LogBufferSize] Size of the log trace buffer in bytes. 5 characters 1000
[Output Type] Output format of the switch. ASCII ASCII
[EndRecordNum] Ending record for message range. Log trace prints
messages within specified range. All messages are
sent to the client. However, messages can be filtered
by setting the log trace flags on the switch. 5 characters infinity
[FilterModuleId] Module ID flag. Only log messages corresponding
to the specified module ID are printed on the
console, otherwise messages from all modules are
printed. See Software Modules
Table on page 2-111 OFF
[Filter SubModuleId] Submodule ID flag. When this flag is on, log
messages are filtered for the submodule ID. See Software
SubModules Table on
page 2-111 OFF
[Filter MessageId] Enables or disables the printing of messages with a
specific message ID. This parameter is intended for
use by field engineers only. When this flag is on, log
messages are filtered for the submodule ID. See Software
SubModules Table on
page 2-111 OFF