3 boot load commands, Boot load commands, 3boot load commands – Cabletron Systems 6A000/ZX-250 User Manual

Page 233

Text mode
Original mode

SmartCell 6A000/ZX-250 Reference Manual 3-1

Boot Load Commands

BOOT LOAD COMMANDS

This chapter describes the low-level boot load commands. Boot load commands are used for setting switch start-up behavior and for
performing software downloads. Use the boot load commands to:

•

Set which copy of the boot load software is the default copy

•

Clear all configurations stored within the flash file system

•

Check boot load software version numbers

•

Load switch software upgrades

•

Set whether power on system tests (POST) are run by default

For detailed information on using the boot load Commands, see your product’s
SmartCell User Guide.

The commands described in this section are intended to be used only for loading
upgrade software or to reinstall software that has become corrupt.