Cabletron Systems 6A000/ZX-250 - Manual (Page 183)

SmartCell 6A000/ZX-250 Reference Manual 2-159
Console Commands
Reboot
Use Reboot to reboot the switch. Enter Reboot with caution as it is instantly entered without offering the chance to
confirm your decision.
Operator
reboot
Parameters
This command has no parameters. Just type reboot at the switch prompt and the switch reboots. You should be aware
that there is no confirm option.
Description
SERVER SVC
X X
Operator Parameters/Permissions Description
reboot [Reboot] <reboot>
Administrator
Reboots the switch. Be aware that most switch attributes are
persistent, so if you reboot, you will need to manually start any
switch attribute that you had stopped before the switch reboot
(for example, the LECS switch attribute).
Do not enter this command from a telnet session because it
breaks any connection you have with the switch. You should be
located near the switch—most probably the switch console—so
you can conveniently reconnect to the switch from there.
Press any key during the first seven seconds after entering this
command as a way to avoid the full switch diagnostic session.
By pressing any key and then typing
go , the switch will conduct
a basic diagnostic session. See the following example for more
details: