Rockwell Automation FlexPak 3000 Power Module Version 4.2 - Manual (Page 50)

DRIVE SETUP AND ADJUSTMENT
FlexPak 3000 49’1340 e 4-8
4.8 Accessing the Main Menu
The Main Menu is accessed by pressing the PROGRAM/MONITOR key until "PROGRAM"
appears above the key.
The Main Menu consists of sub-menus that can be used to quick start your drive, select drive
reference, tune the speed/voltage loop and/or current minor loop, configure input/output
terminals for metering, set up the field, configure SCR diagnostics, or display drive information
and operator interface selections. The following tree provides the overview of the Main Menu at
a glance.
FlexPak 3000 Main Menu
 Quick Start

 Drive Reference

 Speed/Voltage Loop (SPD)

 Current Minor Loop (CML)

 Outer Control Loop (OCL)

 Input/Output

 Network Communication

 Field

 Drive Information

 Operator Interface

 Additional Parameters
The sub-menus in the Main Menu list contain lower level menu lists and/or parameter lists for
configuring, tuning, setup, monitoring or troubleshooting the drive.
4.9 How to Access the Menus/Parameters
Position the cursor at the menu/parameter of your choice using the up/down arrow keys and then
press the ENTER key to access. If a # character displayed at the bottom left of a menu/
parameter list indicates that more selections are available. Press the down arrow key to scroll up
through the selections. Similarly, if a $ character is displayed at the top left of a menu/ parameter
list, use the up arrow key to scroll down through the selections.
Using the following paths starting from the Main Menu, the user can access parameters to
monitor, setup, adjust, configure and tune the drive using value entry screens.
Drive Reference Speed/Voltage Loop (SPD)

 Drive Reference

 Drive Reference Test Points*

 Drive Reference Trim*

 Drive Reference Limits*

 Drive Reference Ramp*

 Drive Reference Configure*

 Drive Reference Scaling*

 Speed/Voltage Loop (SPD) Test Points*

 Speed/Voltage Loop (SPD) Tuning
  Self Tuning Setup*
  Self Tuning

 Speed/Voltage Loop (SPD) Feedback*