Rockwell Automation FlexPak 3000 Power Module Version 4.2 - Manual (Page 157)

APPENDIX C
49’1340 e FlexPak 3000 C-1
FlexPak 3000 User Output Parameter Records
This appendix provides an alphabetized list of output parameters with their associated description and
the menu path(s) for access. Reference Appendix D, Speed Loop & CML Block Diagrams, for the
relation of these parameters in the signal flow of their associated loops.
AC LINE PERIOD (P.393)
The A-C line period as measured by the drive in microseconds. Line period = 1/line frequency in Hertz.
OIM Menu Path(s): Current Minor Loop (CML) - Three Phase AC Line
AC LINE VOLTAGE (P.392)
The A-C line RMS voltage as measured by the drive.
OIM Menu Path(s): Current Minor Loop (CML) - Three Phase AC Line
ANALOG AUTO REFERENCE (P.188)
Auto mode analog reference value measured by the drive after all hardware and software scaling.
OIM Menu Path(s): Drive Reference - Drive Reference Scaling
Drive Reference - Test Points
ANALOG MAN REFERENCE (P.192)
Manual mode analog reference value measured by the drive after all hardware and software scaling.
Only used when the drive is set as a speed/voltage regulator.
OIM Menu Path(s): Drive Reference - Drive Reference Scaling
Drive Reference - Drive Reference Test Points
ANALOG MAN TRIM REF (P.194)
Represents the speed/voltage loop reference trim signal after gain and offset adjustments.
Only used when the drive is set as a speed/voltage regulator.
OIM Menu Path(s): Drive Reference - Drive Reference Scaling
Drive Reference - Drive Reference Test Points
ANALOG TACH FEEDBACK (P.291)
The digital value of the analog tachometer feedback input after all hardware and software scaling.
For use with analog tachometer feedback (A-C or D-C) only.
OIM Menu Path(s): Speed/Voltage Loop (SPD) - Speed/Voltage Loop (SPD) Test Points
Speed/Voltage Loop SPD - Feedback