Rockwell Automation GV3000/SE AC Drive AutoMax Network Communication Board, M/N 2AX3000 - Manual (Page 92)

Index Index-1
I
NDEX
75 ohm terminating load, 1-2
A
alternative synchronization methods, 4-4
AutoMax
Network Communication Option board,
description, 1-1
network, connecting to, 2-38
Processor, 1-2
Programming Executive, 1-2
B
base drop number, 3-2
basic drive connection, 3-1, 3-2, 3-3
broadcast
reference, 3-7
trim reference, 3-8
C
clear error log bit, 4-4
communication loss, response to, 3-4
Communications Passive Tap, 1-2
configurable
data, 4-1
inputs
enabling transfer, 4-2
timing, 4-4
configuring
drive, 3-1
network communication, 3-1
Control and Configuration Software, 1-2
Control Source (P.000), 3-1
control sources and network, 4-1
control/reference data, 4-1
timing, 4-4
ControlNet Network Communication Option Board,
3-2
counter register, pulse encoder, 4-5
cross reference, parameter to register, B-1
CS3000 software, 1-2
D
DeviceNet Network Communication Option Board,
3-2
direct
reference, 3-7
trim reference, 3-8
drive
configuration, 3-1
connecting to AutoMax network, 2-38
power-up, 3-2
ready status bit, 4-5
response to network communication loss, 3-2,
3-4
drop cable, installing, 2-38
drop number, 3-2
Drop_1
read only registers, 5-2
read/write registers, 5-5
Drop_2
read only registers, 5-8
read/write registers, 5-10
Drop_3, 4-5
vector
read only registers, 5-12
read/write registers, 5-13
volts/hertz
read only registers, 5-15
read/write registers, 5-16
drops, 3-1
E
enabling transfer of tunable and configurable
inputs, 4-2
error
log, clearing, 4-4
status flag, 4-4
F
fault reset, 4-4
full drive connection, 3-1, 3-2, 3-3