Rockwell Automation GV3000/SE AC Drive AutoMax Network Communication Board, M/N 2AX3000 - Manual (Page 63)

4-6 AutoMax Network Communication Option Board for the GV3000/SE AC Drive
Update times assume communication is active. Outputs are transferred whenever
communication is active. Inputs are only transferred when communication is active
and P.000 is set to 2 (OP). See section 4.3 for information on setting up transferrable
data types.
4.9 GV3000/SE Drive Parameters Not Accessible Over
the Network
The following GV3000/SE drive parameters are not accessible over the AutoMax
network at any time.
P.006, Second Menu Password
P.007, Terminal Strip Digital Inputs Configure
P.008, Terminal Strip Speed Reference Source
P.017, Accel Time 2 (RAMP 2)
P.018, Decel Time 2 (RAMP 2)
P.023, MOP Accel/Decel Time
P.024, MOP Reset Configuration
P.031, Preset Speed 1
P.032, Preset Speed 2
P.033, Preset Speed 3
P.034, Preset Speed 4
P.035, Preset Speed 5 P.036, Preset Speed 6
P.037, Preset Speed 7
P.038, Preset Speed 8
P.050, Restore Defaults
P.051, Programming Disable
P.060, Network Drop Number
P.090, Diagnostics Source
P.091, Diagnostics Display
U.008, Torque Self-Tune Enable
H.020, Identification Request
RMI (r.) parameters