beautypg.com

Rockwell Automation GV3000/SE AC Drive AutoMax Network Communication Board, M/N 2AX3000 User Manual

Page 46

background image

Installation

2-37

Step 4.

Reattach the Cover

Step 4.1 Remove enough tabs on the faceplate breakout panel to allow the Network

Drop Cable through.

Step 4.2 Route the Network Drop Cable through the breakout panel.

Step 4.3 Reconnect the keypad/display cable to the cover.

Important: For 24 to 30 amp drives, fold and slide the keypad/display cable under the

heatsink at the top of the drive before attaching the cover.

Step 4.4 Reattach the cover using the single faceplate screw.

Step 4.5 Reconnect all faceplate wiring.

This completes the hardware installation of the AutoMax Network option board. Do not
remove the lockout and tag until you have completed section 2.10, which provides
instruction on connecting to the AutoMax network.

Figure 2.20 – Installing the AutoMax Network Option Board in GV3000/SE Bookshelf Drive

Regulator Board

Keypad/Display

Regulator Board
Ribbon Cable

Cable Connector

AutoMax Network
Option Board