Rockwell Automation 25B PowerFlex 520-Series Adjustable Frequency AC Drive User Manual - Manual (Page 138)

138 Rockwell Automation Publication 520-UM001G-EN-E - September 2014
Chapter 3 Programming and Parameters
AppView Parameter Groups AppView parameter groups provide a simple starting point for using the
PowerFlex 520-series drives by grouping certain commonly used parameters
based on different types of applications. Use these parameter groups to quickly
and easily setup the PowerFlex 520-series drive for your application.
AppView parameter groups are available for the following applications:
• Conveyor
• Mixer
• Compressor
• Centrifugal Pump
• Blower/Fan
• Extruder
• Positioning (PowerFlex 525 only)
• Textile/Fiber
You cannot add or remove parameters to or from the AppView parameter groups.
If you require quick access to additional parameters to what is already included in
the different AppView parameter groups, use the CustomView parameter group
instead.
The parameters in the AppView parameter groups can be quickly added to the
CustomView parameter group by doing the following:
Step Key(s) Example Displays
1. Press the Up Arrow or Down Arrow to scroll to
an AppView group (G1...G8).
2. Press Enter or Sel to enter a group. The right
most digit of the last viewed parameter in that
group will flash.
3. Press the Up Arrow or Down Arrow to scroll to
the command G1->GC.
4. Press Enter or Sel to add all the parameters in
this AppView group to the CustomView group.
The LCD display will show a confirmation.
or
FWD
Sel or
FWD
or
FWD
Sel or