Det-Tronics S3 Graphics - Manual (Page 96)

EAGLE QUANTUM PREMIER CONFIG. 11-15 EAGLE QUANTUM PREMIER CONFIG.
Version 6.0
Point Address
Allows a node on the LON schematic to be given a different address.
This is typically used when similar nodes are copied & pasted to preserve a particular set of configuration
parameters. After the paste function, the “new” node may have an incorrect address and it must then be
changed.
To use this function, select a node by single-clicking on its rectangle. Once the node is highlighted, click on the
“Point Address” button and the “Enter new point address” dialog box will appear. Enter the desired new node
number and the click on the “OK” button.
Set RTC
Sends the current date and time of the S 3 station to the controller synchronizing them. Since the field devices all
use the controllers date and time pulse when storing their own alarm and calibration data, it is important to verify
the proper time on the PC and then match the clock used by S 3 station for event monitoring and tracking.
COMMAND BAR • POINT ADDRESS COMMAND BAR • LON DIAGNOSTIC