Det-Tronics S3 Graphics - Manual (Page 93)

11-12 EAGLE QUANTUM PREMIER CONFIG.
Version 6.0
EAGLE QUANTUM PREMIER CONFIG.
Reset Module
This command forces a selected field device to perform a “soft restart” effectively “rebooting” the field device.
This will also reset any latched alarms, faults, outputs, etc.
The reset command can be sent to a single selected device
or a group of devices. In the example to the right a group of
nodes 1-125 was selected from the LON schematic and the reset
command issued.
The controller then sent the reset command to the appropriate
devices and logged the activity to the “Reset Module(s)” dialog
box to provide feedback to the user.
Download
Sends all configuration data from S 3 ’s LON configuration database
to the controller. This command must be used after changing the
configuration of a node, group of nodes, or controller logic.
To send configuration data to the devices on the LON, choose “Download”. This will cause S 3 to sequentially
download the configuration of all nodes, starting with LON address 1 and ending with the last configured node.
Get RTC
Requests the “Real Time Clock” data from the controller.
The gateway will return the current date and time, according
to its internal clock. Verify this date and time against that
of the S 3 station for accuracy. If it is not the same as the S 3
station, use the Set RTC command described later to correct
the discrepancy.
COMMAND BAR • RESET MODULE