Det-Tronics S3 Graphics - Manual (Page 38)

5-3 PRINTING
Version 6.0
Selecting ports to document
Port 1 - 10
S 3 supports up to ten ports. Each port can be physical serial port or an Ethernet
connection.
Note
A single ethernet card can support multiple ports!
In the example to the right, ports one and three are configured and therefore
selectable. The ports not configured are grayed out.
Each selected port will have its documentation printed.
Port documentation includes all aspects of the configuration including the
communication parameters and any configured points, events, alarms,
setpoints, custom event names, etc. Each configured point has one page of
printed configuration data.
Once all of the selections for the documentation and ports to print have been
made, select the “OK” button to access the “Print Setup” dialog box for the
Windows-NT/2000/XP/Vista default printer and continue the printing process.
Once the print configuration is set, selecting OK will display the “Print Setup”
dialog box for the Windows-NT/2000/XP/Vista default printer.
In the example below an HP LaserJet 5000 network printer is the
Windows-NT/2000/XP/Vista default.
Depending on the default printer installed the dialog box and choices available will vary.
Note
the okidata event and alarm
printer specified for use with
S 3 can be configured as the
Windows-Nt/2000/XP/Vista
default printer and used for
documentation. However, due to
the volume of paper and printer
speed, it is not recommended.
PORT SELECTION DOCUMENTATION SELECTION