Serial port settings, Ports – Det-Tronics S3 Graphics User Manual
Page 26
3-3
PORTS
Version 6.0
PORT CONFIGURATION
Serial Port Settings
Once the port type has been selected, the button face will change to match the selection. In addition, six buttons
on the right hand side of the window will be enabled. These buttons allow various parameters to be adjusted for
any configured port.
Configuration of the device(s) attached to a port, data table reads, etc. are accessed by
double-clicking on the port button, or selecting the “Configure” button.
Physical serial port configuration parameters like baud rate, the number of data bits, etc.
can be accessed using the “Serial Settings” button. This will open a dialog box allowing
the adjustment of the port parameters.
The port parameters can be set manually from the pull-down
menus.
Selecting the “Auto Check” button will cause the software to cycle
through all combinations until it can connect. It will then display
the successful settings.