Det-Tronics S3 Graphics - Manual (Page 279)

13-54 EQP LOGIC EDITOR
Version 6.0
EQP LOGIC EDITOR
Click to and drag to make the connection and create a wire. Draw the wire from the initial wire-to-wire connection
point to the input of the desired variable.
The completed circuit will look like the example below.
If the mouse button is released while “drawing” the wire, before completing the connection, an incomplete line
segment will be created. To complete this segment, use the arrow tool to click and drag the incomplete end of
the wire to its desired destination.
LOGIC CREATION • VARIABLE LINKING