Det-Tronics S3 Graphics - Manual (Page 278)

EQP LOGIC EDITOR 13-53 EQP LOGIC EDITOR
Version 6.0
Wire-on-Wire
This type of connection is used when a single signal needs to be routed to multiple destinations as in the
example below.
In this example the output “Q” of a “Reset-Set (RS)” block needs to be routed to the input of an “AND” gate, to
the input of a timer (TON) and to two output locations on SAM-014. The first connection to SAM-014’s audible
alarm is complete, the second connection to SAM-014’s visible alarm output needs to be created.
To accomplish this type of connection the “Wire Tool” is used. Select the “Wire Tool” and place it on an existing
“wire” where a connection is desired.
LOGIC CREATION • VARIABLE LINKING LOGIC CREATION • VARIABLE LINKING