Det-Tronics S3 Graphics - Manual (Page 321)

13-96 EQP LOGIC EDITOR
Version 6.0
Item 314 - Serial Port 2 Parity
The parity setting for the second configurable serial port is set with this variable. The default parity is “None”.
Refer to the data type section of this document for the parity data values.
Item 315 - Serial Port 2 Address
This address field is used for Modbus protocol, valid Modbus addresses are in the range from 1 to 247 with a
default value of 1.
Item 316 - Serial Port 3 Protocol
Serial Port Protocols
Value Description
1 Port not used
2 Modbus Slave
3 Modbus Master
4 S 3
Item 317 - Serial Port 3 Baud Rate
Serial baud rate for serial port 3 is set with this variable. . The allowed selections are listed below.
Baud Rate Codes
Code Speed
3 9600
4 19.2K
5 38.4K
6 57.6K
7 115.2K
8 230.4K
Item 318 - Serial Port 3 Parity
Serial port 3 parity is set with this variable. The default parity is “None”. Refer to the data type section of this
document for the parity data values.
Item 319 - Serial Port 3 Address
The address field is only used for Modbus protocol. Valid Modbus addresses are in the range from 1 to 247. The
default address is 1.
Item 320 - Serial Port 4 Protocol
Serial Port Protocols
Value Description
1 Port not used (Debug Output)
2 Modbus Slave
3 Modbus Master
DEVICE ITEM NUMBER DESCRIPTIONS