Det-Tronics S3 Graphics - Manual (Page 311)

13-86 EQP LOGIC EDITOR
Version 6.0
Item 179 - Activate Supervisory
Setting this control bit activates the controller supervisory output, status bit and LED. The output, LED and status
bit will stay true until the controller is reset. The controller clears this control bit after the action is taken.
Item 180 - Latching Fault
Setting this configuration parameter causes the field device to latch the fault status until the device is reset.
Item 181 - Quick Fire Enable
Setting this configuration parameter enables quick fire detection method.
Item 182 - Bin Disabled Signaled by LED
Setting this configuration parameter enables “Bin Disabled Signaled by LED” feature in the X3301.
Item 183 - Heater Power
This configuration parameter determines what percent of power will be used for the optics heaters.
Item 184 - Temperature Setpoint
This configuration parameter determines the temperature at which the internal heaters are activated.
Item 185 - Consecutive Failed Oi Tests for Fault
This configuration parameter determines how many consecutive Oi tests must fail before a fault is generated.
Item 186 - User Logic Scan Time
This status variable holds the number microseconds needed to complete the user logic.
Item 187 - Power Fail 1
This controller sets this status variable when low voltage is detected on the power input #1.
Item 188 - Power Fail 2
This controller sets this status variable when low voltage is detected on the power input #2.
Item 189 - Output Inhibit
This controller sets this status variable when any outputs are inhibited, this includes the controller and field device
outputs.
Item 190 - High Energy Detected
A field device sets this status bit to indicate that high energy was detected.
Item 191 - High Energy Fault
A field device sets this status bit to indicate that high energy was detected for a sustained period of time.
Item 192 - Non-Ratio Mode Fault
A field device sets this status bit to indicate that a non-ratio mode fault occurred.
Item 193 - Bin Disable
A field device sets this status bit to indicate that the bin fire detection mode is disabled.
Item 194 - Quick Energy Disabled
A field device sets this status bit to indicate that the quick energy detection mode is disabled.
DEVICE ITEM NUMBER DESCRIPTIONS