New device, Eagle quantum premier config – Det-Tronics S3 Graphics User Manual
Page 113
11-32
EAGLE QUANTUM PREMIER CONFIG.
Version 6.0
EAGLE QUANTUM PREMIER CONFIG.
CONFIGURATION BAR • CONTROLLER LOG
New Device
Opens the “Select Point Type” dialog box from which a new device can be added to the LON.
In the example below, “Initiating Device Circuit (IDC)” has been selected.
At this point, selecting the “OK” button would add an IDC to the LON, just after the last configured device.
At this point, the configuration dialog box for the selected point type is displayed. This dialog box provides access
to all of the programmable parameters for the selected device type. The detailed configuration instructions for
each device type is covered in svection 12.
NOTE
Verify the proper LON address for the new device is shown in the “point number” window; correct if not.
CONFIGURATION BAR • NEW DEVICE