JLG G12-55A AccuPlace Service Manual - Manual (Page 184)

Electrical System
9.66 G10-55A & G12-55A AccuPlace
SWAY JOYSTICK
– NEUTRAL
DISAGREEMENT 2359 The Sway joystick is within
its deadband and one of the
directional switches is closed
or the joystick is outside its
deadband and the
respective directional switch
is not closed; debounce 2
seconds. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Sway
joystick and an adjacent Mini Joystick to
determine whether the Sway joystick is
faulty. If the joystick is fine, focus
troubleshooting efforts on the connector
and wiring as detailed in DTC 2126.
Check continuity of wiring connections.
SWAY JOYSTICK
– OUT OF RANGE
HIGH 2360 The Sway joystick voltage
has reached the high error
limit defined in Personalities. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Sway
joystick and an adjacent Mini Joystick to
determine whether the Sway joystick is
faulty. If the joystick is fine, focus
troubleshooting efforts on the connector
and wiring as detailed in DTC 2126.
Check continuity of wiring connections.
SWAY JOYSTICK
– OUT OF RANGE
LOW 2361 The Sway joystick voltage
has reached the low error
limit defined in Personalities. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Sway
joystick and an adjacent Mini Joystick to
determine whether the Sway joystick is
faulty. If the joystick is fine, focus
troubleshooting efforts on the connector
and wiring as detailed in DTC 2126.
Check continuity of wiring connections.
LEFT
STABILIZER
JOYSTICK –
NEUTRAL
DISAGREEMENT 2362 The Left Stabilizer joystick is
within its deadband and one
of the directional switches is
closed or the joystick is
outside its deadband and the
respective directional switch
is not closed; debounce 2
seconds. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Left
Stabilizer joystick and an adjacent Mini
Joystick to determine whether the Left
Stabilizer joystick is faulty. If the joystick is
fine, focus troubleshooting efforts on the
connector and wiring as detailed in DTC
2128.
Check continuity of wiring connections.
Help Message
1
DTC Fault Condition
(for configurable items,
fault applies only if
configured)
Fault
Requires
AccuPlace
Reset?
Action(s)