JLG G12-55A AccuPlace Service Manual - Manual (Page 173)

9.55 G10-55A & G12-55A AccuPlace
Electrical System
FORK VALVE
2
FORK PRESS-HEAD: XXXX.X PSI Pressure reported from Work Port 1 (Head).
FORK PRESS-LS: XXXX.X PSI Pressure reported from Fork Shuttle Valve.
FORK TEMP-HEAD: ±XXXDEG C Temperature reported from Work Port 1.
FORK TEMP-LS: ±XXXDEG C Temperature reported from Fork Shuttle Valve.
FORK COIL 1 CMD: XXXXmA Current commanded to Fork Coil 1.
FORK COIL 1 FDBK: XXXXmA Current returning from Fork Coil 1.
FORK COIL 2 CMD: XXXXmA Current commanded to Fork Coil 2.
FORK COIL 2 FDBK: XXXXmA Current returning from Fork Coil 2.
AUX COIL 1 CMD: XXXXmA Current commanded to Fork Coil 3.
AUX COIL 1 FDBK: XXXXmA Current returning from Fork Coil 3.
AUX COIL 2 CMD: XXXXmA Current commanded to Fork Coil 4.
AUX COIL 2 FDBK: XXXXmA Current returning from Fork Coil 4.
CALIBRATION
DATA
2
BOOM ANGLE LT: CAL LOW XXXXX Calibration offset for Boom Down of Boom Angle
Left Sensor (CAN).
BOOM ANGLE LT: CAL HIGH XXXXX Calibration offset for Boom Up of Boom Angle Left
Sensor (CAN).
BOOM ANGLE RT: CAL LOW XXXXX Calibration offset for Boom Down of Boom Angle
Right Sensor (Analog).
BOOM ANGLE RT: CAL HIGH XXXXX Calibration offset for Boom Up of Boom Angle
Right Sensor (Analog).
TELE SENSOR CAL: RET XXXXX Calibration offset for Boom Retracted of Tele
Length Sensor.
TELE SENSOR CAL: EXT XXXXX Calibration offset for Boom Extended of Tele
Length Sensor.
FORK SENSOR CAL: LOW XXXXX Calibration offset for Fork Down of Fork Angle
Sensor.
FORK SENSOR CAL: HIGH XXXXX Calibration offset for Fork Up of Fork Angle
Sensor.
Diagnostics
Submenu
(Displayed on
Analyzer 1
st
Line)
Parameter
(Displayed on
Analyzer 1
st
Line)
Parameter Value
(Displayed on
Analyzer 2
nd
Line)
Description