JLG G12-55A AccuPlace Service Manual - Manual (Page 183)

9.65 G10-55A & G12-55A AccuPlace
Electrical System
BOOM RIDE
MODE SWITCH
CLOSED AT
POWER UP
2
2355 Boom Ride Mode Switch
read by UGM as closed
during system startup. N Turn Boom Ride Mode switch off (open
state), then back on (closed state).
Press button to confirm that button is
functional. If fault persists, check under
Diagnostics/Ground to verify that the
switch changes state. Check to determine
whether a power cycle will clear the DTC.
Check continuity of wiring connections.
AUXILIARY
HYDRAULICS
JOYSTICK –
NEUTRAL
DISAGREEMENT 2356 The Aux Hydraulic joystick is
within its centered deadband
and one of the out-of-neutral
directional switches is closed
or the joystick is outside its
deadband and the
respective directional switch
is not closed. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Aux
Hydraulics joystick and an adjacent Mini
Joystick to determine whether the Aux
Hydraulics joystick is faulty. If the joystick
is fine, focus troubleshooting efforts on the
connector and wiring as detailed in DTC
2127.
Check continuity of wiring connections.
AUXILIARY
HYDRAULICS
JOYSTICK – OUT
OF RANGE HIGH 2357 The Aux Hydraulic joystick
voltage has reached the high
error limit defined in
Personalities. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Auxiliary
Hydraulics joystick and an adjacent Mini
Joystick to determine whether the
Auxiliary Hydraulics joystick is faulty. If the
joystick is fine, focus troubleshooting
efforts on the connector and wiring as
detailed in DTC 2127.
Check continuity of wiring connections.
AUXILIARY
HYDRAULICS
JOYSTICK – OUT
OF RANGE LOW 2358 The Aux Hydraulic joystick
voltage has reached the low
error limit defined in
Personalities. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Auxiliary
Hydraulics joystick and an adjacent Mini
Joystick to determine whether the
Auxiliary Hydraulics joystick is faulty. If the
joystick is fine, focus troubleshooting
efforts on the connector and wiring as
detailed in DTC 2127.
Check continuity of wiring connections.
Help Message
1
DTC Fault Condition
(for configurable items,
fault applies only if
configured)
Fault
Requires
AccuPlace
Reset?
Action(s)