Infinity hardware specifications – AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual
Page 82
76
© 2014 AEM Performance Electronics
Infinity User Manual
A firmware update will erase the USB log channel list stored in the ECU memory. This
channel list will need to be reset before USB logging will function correctly. See
for more info.
Troubleshooting:
If the process hangs at any point, wait at least one minute for it to continue. Some PCs
take longer to reconnect to to the ECU during this process. Some PCs may have other
processes running that affect the response time of the USB ports. If the process has
not continued as described above after one minute, do not cycle key power. Instead,
remove the USB cable from the PC, wait a few seconds then plug it back in. Often this
will force the OS to reset the port allowing the process to continue.
Infinity Hardware Specifications
Specifications
Infinity-6
Infinity-8h
Infinity-8
Infinity-10
Infinity-12
Cylinders
Up to 6
Up to 8
Up to 8
Up to 10
Up to 12
Injectors, Low
Impedance
(Sequential)
6
N/A
8
10
12
Injectors High
Impedance
(Sequential)
Up to 6
Up to 8
8
10
12
Coils – 0–5V
Falling Edge
6
8
8
10
12
Connector Pins
80
80
129
129
129
Drive-by-Wire
Single
Single
Dual
Dual
Dual
H-Bridge
Channels
1
1
2
2
2
RS232 Channels*
1
1
1
1
1
CAN Channels
2
2
2
2
2
2-Stroke Engines
Yes
Yes
Yes
Yes
Yes
4-Stroke Engines
Yes
Yes
Yes
Yes
Yes
Knock Control
2-Channel
2-Channel
2-Channel
2-Channel
2-Channel
Analog Voltage
Inputs
Up to 9
Up to 9
Up to 17
Up to 17
Up to 17
Analog Temp
Inputs
Up to 3
Up to 3
Up to 6
Up to 6
Up to 6
30