AEM 30-2011 Water Temp Sensor Kit - Manual

AEM Performance Electronics
2205 126 th Street Unit A, Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
http://www.aemelectronics.com
Instruction Part Number: 10-2011 Rev B
© 2011 AEM Performance Electronics
The model 30-2011 Water Temp Sensor kit is specifically designed for fluid temperature measurements in automotive
systems. The kit contains One GM style temperature sensor, the mating connector, 2 terminals and a weld in aluminum
bung.
Housing Material: Brass with 3/8” NPT Thread (Torque to 25 Ft-Lbs)
Elec. Termination: Integral weatherproof connector, Includes mating connector with 2 terminals.
IMPORTANT!
The terminals are “Pull to Seat” meaning you must feed the wire through the connector housing BEFORE you crimp on
the terminals. The wire is then pulled back into the housing and the terminal locks in place. The terminal cannot be
inserted or removed from the rear (wire side entry) of the housing
Wiring to your EMS: Polarity does not matter. Take one wire and tap it to sensor ground at the ECU connector and take
the other wire and hook it up directly to the CLT (Coolant temp) sensor input on the EMS. Please reference your EMS
instructions for pin out details and locations.
Instruction Manual
P/N 30-2011 Water Temp Sensor