AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual - Manual (Page 371)

Wiring, Pinouts and Schematics 365
© 2014 AEM Performance Electronics
Infinity Pin Hardware Ref. Hardware Specification Notes
C1-31* Dig6 [Hz] / Dig6_Duty_In
(*Infinity-6 Only) 10K pullup to 12V. Will work with
ground or floating switches. Available on P/N 30-7106 only. Frequency input
can be assigned to Wheel Speed, TurboSpeed,
Flex Fuel or other functions. See Setup Wizard
page Input Function Assignments for mapping
options.
C1-31** Coil 7_Out
(**Infinity-8H Only) 25 mA max source current Available on P/N 30-7108 only. 0-5V Falling edge
fire. DO NOT connect directly to coil primary.
Must use an ignitor OR CDI that accepts a
FALLING edge fire signal.
C1-32* Digital_In_7
(*Infinity-6 Only) 10K pullup to 12V. Will work with
ground or floating switches. Available on P/N 30-7106 only. Input can be
assigned to different pins. See Setup Wizard
page Input Function Assignments for input
mapping options.
C1-32** Coil 8_Out
(**Infinity-8H Only) 25 mA max source current Available on P/N 30-7108 only. 0-5V Falling edge
fire. DO NOT connect directly to coil primary.
Must use an ignitor OR CDI that accepts a
FALLING edge fire signal.
C1-33 Power Ground_In Power Ground
Connect directly to battery ground
C1-34 CANL_A_Out Dedicated High Speed CAN Transceiver Recommend twisted pair (one twist per 2") with
terminating resistor. Contact AEM for additional
information.
C1-35 CANH_A_Out Dedicated High Speed CAN Transceiver Recommend twisted pair (one twist per 2") with
terminating resistor. Contact AEM for additional
information.
C1-36 CanL_B_Out Dedicated High Speed CAN Transceiver Not used, reserved for future expansion.
C1-37 CanH_B_Out Dedicated High Speed CAN Transceiver Not used, reserved for future expansion.
C1-38 Analog_In_Temp_1 12 bit A/D, 2.49K pullup to 5V See "Coolant Temperature" Setup Wizard for
selection.
C1-39 Analog_In_Temp_2 12 bit A/D, 2.49K pullup to 5V See "Air Temperature" Setup Wizard for
selection.
C1-40 Analog_In_Temp_3 12 bit A/D, 2.49K pullup to 5V See 1D table OilTempCal table for calibration
data and OilTemp [C] for channel data.
C1-41 Lowside Fuel Pump
drive_Out Lowside switch, 1.7A max, NO internal
flyback diode.
No pullup
Switched ground. Will prime for 2 seconds at
key on and activate if RPM > 0.
C1-42 LowsideSwitch_1_In Lowside switch, 6A max with internal
flyback diode. Inductive load should
NOT have full time power.
No pullup
See Setup Wizard page Boost Control for
options. Monitor BoostControl [%] channel for
output state.
C1-43 Power Ground_In Power Ground
Connect directly to battery ground
C1-44 Knock Sensor 1_In Dedicated knock signal processor See Setup Wizard page Knock Setup for options.
C1-45 Knock Sensor 2_In Dedicated knock signal processor See Setup Wizard page Knock Setup for options.
C1-46 Power Ground_In Power Ground