beautypg.com

AEM 30-2310 Inline Wideband UEGO Controller User Manual

Installation

background image

Part Number 30-2310

INLINE WIDEBAND UEGO CONTROLLER

Figure 1. Wiring Schematic

Inline Wideband UEGO Controller Parts
1 x 30-2310 Inline Wideband UEGO Module
1 x 30-2001 UEGO Sensor
1 x 35-8535 Install Kit (UEGO Bung and 6 Butt Connectors)
1 x 10-2310 Installation Instructions
2 x Zip Tie


INSTALLATION

1. Disconnect the negative battery cable.
2. Find a suitable in-cab or under hood mounting location for the Inline UEGO

controller, away from any direct heat or water sources and shielded from the
elements. Secure the controller using the supplied zip ties as shown in Figure 3.

3. Connect the flying lead wires as shown in Figure 1.
4. Mount the UEGO sensor as shown in figure 2.
5. Plug the UEGO sensor connector on the UEGO controller into the mating

connector on the UEGO sensor.

AEM Performance Electronics

2205 126

th

Street Unit A, Hawthorne, CA. 90250

Phone: (310) 484-2322 Fax: (310) 484-0152

http://www.aemelectronics.com

Instruction Part Number: 10-2310 Rev 02

© 2011 AEM Performance Electronics