beautypg.com

AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual

Page 254

background image

248

© 2014 AEM Performance Electronics

Infinity User Manual

Boost Integral Gain High Clamp
Units:
Clamp
Description: This keeps the integral gain from winding up and limits its contribution.
Min value = -10, Max value = 10. Note: BoostControlIntClampH must be greater than
BoostControlIntClampL.

Boost Integral Gain High Clamp
Units:
Clamp
Description: This keeps the integral gain from winding up and limits its contribution.
Min value = -10, Max value = 10. Note: BoostControlIntClampH must be greater than
BoostControlIntClampL.

Boost Solenoid Min Throttle
Units:
%
Description: Below this TPS value, the boost duty output is disabled.
Min value = 0, Max value = 100.

BoostBaseDuty1 [% ]
Units:
Selectable via setup wizard
Description: Base wastegate duty cycle as a function of selectable axis inputs. This table is
used to set the base duty cycle to the boost control solenoid. Set this by disabling the feedback
controls first. This is done by setting the BoostControl_Kp, BoostControl_Ki, and
BoostControl_Kd all to zero. Adjust this table until the desired boost is as closely achieved as
possible. The closer this table gets to the targeted boost pressure, the better the closed loop
boost control feedback will work. This table determines the base duty cycle percentage used if or
if not using closed loop boost control feedback. This is the first feature to tune when using boost
control.