beautypg.com

AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual

Page 310

background image

304

© 2014 AEM Performance Electronics

Infinity User Manual

Before a fuel system is assembled in the vehicle, inspect for debris and damages. Make sure to
have a fire extinguisher near by in case of fire when inspecting. After the fuel system is installed
you must inspect the integrity of the entire system. Begin by purging the lines. To do this, run the
fuel pump with the hose that connects to the fuel rail placed in a grounded container. This will
eliminate any debris left in hose during its manufacturing process. Inspect the fuel rail for
cleanliness before starting the engine. Make sure that the fuel pressure is set correctly for your
application. Then, reattach all of the hoses and run the fuel pump by switching the ignition to the
“ON” position (DO NOT turn over the engine at this time), and visually inspect all of the
connections for fuel seepage or leaks. If any seepage or leaks are present in the system, repair
them before proceeding.