Software, Software installation, Device driver installation – AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual
Page 10
4
© 2014 AEM Performance Electronics
Infinity User Manual
Software
Software Installation
All current Infinity Tuner software installations and drivers are available for download from AEM
at
1. Run the setup.exe. Hit Next> and follow the instructions on each page.
2. Read and accept the terms of agreement and pick your desired location for Infinity Tuner to
be installed. Hit Next> and allow the software to complete installation.
3. You may now exit the Infinity Tuner installer. You can now run Infinity Tuner. To use Infinity
Tuner with an ECU connected first you will need to install the necessary drivers.
4. If desired, add a desktop link for InfinityTuner. Click the Windows Start button and navigate to
All Programs\InfinityTuner. Right click on the InfinityTuner link and select Send to>Desktop
(create shortcut).
Device Driver Installation
USB drivers are installed automatically as of Infinity Tuner version 2.95.7043. If installation
problems occur, follow the procedure below to manually install the drivers.
USB drivers are available for download from
A step by step guide for driver installation is documented in the following
...or copy and
paste the following link into a web browser:
1. For these next steps the Infinity ECU will need to be installed and powered up. Refer to your
harness instructions details. You will need the ignition key in the on position. Connect your
computer to the ECU via the USB cable.