Injectors – AEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual
Page 337

Wiring, Pinouts and Schematics
331
© 2014 AEM Performance Electronics
Injectors
The Infinity ECU has integrated peak and hold injector drivers. This means the Infinity can drive
high impedance or low impedance fuel injectors without using resistors to keep the current low.
Note: With fuel injectors, polarity does not matter. This means the positive and negative wires
can go on either injector pin.
AEM P/N 30-2020 (Optional)
This Bosch Style Injector Connector Kit contains the parts to assemble 4 injector connectors. The
kit contains Four Bosch style female injector connectors and 10 contacts (2 extra contacts are
included for spares).
IMPORTANT!
The contacts are “Pull to Seat” meaning you must feed the wire through the connector housing
BEFORE you crimp on the contacts. The wire is then pulled back into the housing and the
contact locks in place. The contact cannot be inserted or removed from the rear (wire side entry)
of the housing.
Contacts (10 Included)
Plating
Tin Plated
Cable Range
1.00–0.05 mm2
Outside Cable Diameter
2.40–2.03 mm2
Temperature Range
-40 to 125 C
Resistance in mOhms at 20 mV
> 10.0 Ohms
Voltage Drop in mV per amp
> 3.0 Ohms
Housing (4 Included)
Color
Black
Cavities or Contacts
2
Gender
Female
Temperature Range
-40 to 125 C
Resistance at 20 mV
> 10.0 mOhm
Voltage Drop per amp
> 3.0 mV
Exterior Dimensions
27.8L X 29.6W X 20H
Seating Process
Pull To Seat