Boss Audio Systems GT-10B - Manual (Page 98)

98
Chapter 7 Using the GT-10B Connected to a Computer Via USB
This setting determines whether or not the command (the Direct Monitor command) controlling the Direct Monitor setting (p. 97)
is enabled.
In the computer application, set the audio input port to the GT-10B.
If passing audio data through the software you’re using, switch the direct monitor off.
Controlling the Direct Monitor Setting from a Computer
1. The SYSTEM MENU screen appears.
2.
Select USB.
3.
The USB screen appears.
4. Move the cursor to Monitor Cmd.
5. Set the desired value.
Parameter/
Range
Explanation
Disable The Direct Monitor command is disabled, maintaining the Direct Monitor mode set by the GT-10B.
Enable The Direct Monitor command is enabled, allowing the Direct Monitor mode to be switched from a computer.
Recording the GT-10B’s Output with a Computer
SYSTEM
GT-10B_e.book 98 ページ ２００８年２月２６日 火曜日 午後３時３０分