Boss Audio Systems GT-10B - Manual (Page 127)

127
Chapter 8 Parameters Guide
Chapter
8
*1 The Int Trig, Int Time, and IntCurve parameters are enabled when
the SOURCE parameter is set to INTERNAL PDL.
*2 The WaveRate and Waveform parameters are enabled when the
Source parameter is set to WAVE PEDAL.
TARGET PARAMETER
COMP (Compressor)
OD/DS (Overdrive/Distortion)
PREAMP
EQ (Equalizer)
INPUT SENS
0–100
This adjusts the input sensitivity when INPUT
LEVEL is selected for Source.
The INPUT SENS parameter is on page 9 of the
ASSIGN 1–8 screen.
Displayed Parameter (Real Name)
On/Off
Type
COMP Sustain
COMP Attack
LM Threshold (Limiter Threshold)
LM Ratio (Limiter Ratio)
LM Attack (Limiter Attack)
LM Release (Limiter Release)
MB Lo Thres. (Multi Band Low Threshold)
MB Lo Ratio (Multi Band Low Ratio)
MB Hi Thres. (Multi Band High Threshold)
MB Hi Ratio (Multi Band High Ratio)
MB Xover f L
(Multi Band Crossover Fre-
quency Low)
MB Xover f M
(Multi Band Crossover Fre-
quency Middle)
MB Xover f H
(Multi Band Crossover Fre-
quency High)
NA Drive (Natural Drive)
Tone
Level
Displayed Parameter (Real Name)
On/Off
Type
Drive
Tone
Effect Level
Direct Level
Bottom Level
Parameter/
Range Explanation
Displayed Parameter (Real Name)
On/Off
Type
Gain
Bass
Middle
Middle Freq (Middle Frequency)
Treble
Presence
Level
Bright
Deep
Response
Enhancer
Pre Shape
Ultra Low
Ultra High
Gain Sw (Gain Switch)
Solo Sw (Solo Switch)
Solo Level
Speaker Type
Gtr SP Type (Guitar Speaker Type)
Mic Type
Mic Distance
Mic Position
Mic Level
Bottom Level
Direct Level
Displayed Parameter (Real Name)
On/Off
Low Cut
Low Gain
Low-Mid Freq (Low-Middle Frequency)
Low-Mid Q (Low-Middle Q)
Low-Mid Gain (Low-Middle Gain)
Hi-Mid Freq (High-Middle Frequency)
Hi-Mid Q (High-Middle Q)
High-Mid Gain (High-Middle Gain)
High Gain
High Cut
Level
GT-10B_e.book 127 ページ ２００８年２月２６日 火曜日 午後３時３０分