Boss Audio Systems GT-10B - Manual (Page 131)

131
Chapter 8 Parameters Guide
Chapter
8
SEND/RTN (Send/Return)
NS1, NS2 (Noise Suppressor)
(Others)
*1 This parameter is disabled when the SOURCE parameter is set to
Internal Pedal or Wave Pedal.
*2 The Src Mode parameter normally functions using the Toggle
setting (the Src Mode parameter setting is disregarded).
This allows you to connect an external effects device to the
SEND and RETURN jacks and use it as part of the GT-10B’s
effects.
Displayed Parameter (Real Name)
On/Off
Mode
Send Level
Return Level
Displayed Parameter (Real Name)
On/Off
Threshold
Release
Detect
Displayed Parameter (Real Name)
Tuner Sw *1 (Tuner Switch)
ManualModeSw *1 (Manual Mode Switch)
PH LOOP
On/Off
Rec/Play *1
Clear *1
Mute/Play *1
TAP
BPM Tap *1
Delay Tap *1
MIDI
Start/Stop *1 *2
MMCPlay/Stop *1 *2
PATCH
Level Inc.10 *1 (Patch Level Increment 10)
Level Inc.20 *1 (Patch Level Increment 20)
Level Dec.10 *1 (Patch Level Decrement 10)
Level Dec.20 *1 (Patch Level Decrement 20)
Number Inc. *1 (Patch Number Increment)
Number Dec. *1 (Patch Number Decrement)
Bank Inc. *1 (Patch Bank Increment)
Bank Dec. *1 (Patch Bank Decrement)
SEND/RETURN
Parameter/
Range Explanation
SEND/RETURN ON/OFF
Off, On
Switches the SEND/RETURN on/off.
Pressing [MASTER/PEDAL FX] switches
On and Off.
Mode
Switches the SEND/RETURN mode.
Normal
Outputs the input to SEND/RETURN to
the SEND jack and the input from the RE-
TURN jack to the circuit post-SEND/RE-
TURN. Use this when you want to
connect an external effects device serially
in the GT-10B’s effects chain.
fig.04-0160
Direct Mix
Outputs the input to SEND/RETURN to
the SEND jack, mixes the input from the
RETURN jack with the input to SEND/
RETURN (the direct sound), then outputs
this to the circuit post-SEND/RETURN.
Use this when you want to mix the GT-
10B’s effects sounds together with the
sound with the external effects device ap-
plied to it.
fig.04-0170
Branch Out
Outputs the input to SEND/RETURN to
the SEND jack. The input from the RE-
TURN jack is disregarded. For example,
using this with the GT-10B’s reverb and
delay immediately ahead of the SEND/
RETURN allows you to use the SEND
jack as a direct out.
fig.04-0180
Send Lev (Send Level)
0–200
Adjusts the volume of the output to the
external effects device.
ReturnLev (Return Level)
0–200
Adjusts the volume of the input from the
external effects device.
MONO
SEND RETURN
SEND RETURN
SEND
GT-10B_e.book 131 ページ ２００８年２月２６日 火曜日 午後３時３０分