Boss Audio Systems GT-10B - Manual (Page 27)

27
Chapter 1 Outputting Sounds
Chapter
1
Before turning off the power, confirm the following.
• Is the volume on the GT-10B, your amp, and all other connected devices turned down to the minimum level?
• Have you saved any patches containing settings that have been changed? (p. 43)
When the Tuner is turned on, sounds input to the GT-10B are output directly as is (bypassed), and the tuner is activated.
Under these conditions you can then tune your bass.
With the GT-10B’s internal tuner, the Note Name and the Tuning Guide are shown of the display, indicating the difference
between the input sound and the sound in the display.
When the difference from the correct pitch falls within 50 cents, the Tuning Guide then indicates the size of that difference. As you
watch the Tuning Guide, tuning until the center indicator lights up.
fig.07-090
Turning Off the Power
1. Turn off the power to the bass amp (power amp) → any external effects
processors and other devices.
2. Turn the GT-10B’s power off.
Changes in patch settings are lost when the power
is turned off. If you want to save changes in the
settings, carry out the Write procedure (p. 43)
before turning off the power.
Tuning the Bass (TUNER)
Turning the Tuner Function On and Off
1. The tuner is switched on or off.
About the Display During Tuning
Tuning Guide
Note Name
Tuned
Too Low
Too High
GT-10B_e.book 27 ページ ２００８年２月２６日 火曜日 午後３時３０分